My Lawnmower Forum banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
5,899 Posts
Hello Mick and welcome to the forum! Spots to check for tags can be under the seat, under the hood, on the back by the hitch area, below the steering near the floor. I'll see if if I can find something for you unless someone jumps in. Meanwhile enjoy looking through the forum.

Front should be @14 psi and rear @12 psi based upon a a husqvarna I have (just a ballpark) You can vary your pressure depending on your yard conditions and what you are doing with your mower such as using a loader, pushing a blade, dragging a plow etc. Lower pressure for better traction, more pressure for a heavier load.
 

·
Registered
Joined
·
14 Posts
Hello Mick and welcome to the forum! Spots to check for tags can be under the seat, under the hood, on the back by the hitch area, below the steering near the floor. I'll see if if I can find something for you unless someone jumps in. Meanwhile enjoy looking through the forum.

Front should be @14 psi and rear @12 psi based upon a a husqvarna I have (just a ballpark) You can vary your pressure depending on your yard conditions and what you are doing with your mower such as using a loader, pushing a blade, dragging a plow etc. Lower pressure for better traction, more pressure for a heavier load.
X2 what five points said. Them numbers would be a good starting point, usually the rears are a little lower than the fronts.

Good luck:)
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top