My Lawnmower Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
I have an old toro (1992) push mower with a B&B 5.5 engine, Mod#97772 with awalbro carb #lb23. I pulled the carb to rebuild it, and when i was putting it back together i found what they call a governor spring that fell off in process. Can anyone tell me where this spring hooks up to. It also has a needle valve that i think is a high speed idle jet. I dont know how to adjust it. I screwed it all the way in, then backed it out 2 turns, but i am not sure how many it should be. appreciate any help. Geppsr
 

·
Premium Member
Joined
·
6,109 Posts
Can you give us the rest of the numbers on the shroud? What Briggs and Stratton call the type. With that you can look up information about the engine and maybe find what you're looking for.
 

·
Registered
Joined
·
29 Posts
Discussion Starter · #3 ·
toro pusher

The only other numbers i could are 011001 91101404 &20328b I hope these are helpful. Thanks geppsr
 
1 - 5 of 5 Posts
Top