My Lawnmower Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi there, I have a mower that will only work on low side of the switch during transport. I've replaced the switch. Tested it, the input and out from the computer and got ground on both sides.

The way I'm reading the schematic is that the computer should be sending ground in at pin 1-33 and sending power at P1-5, but I'm getting ground at either end. (See attachment, I circled in and out in red).

Any suggestions would be greatly appreciated!
Slope Rectangle Schematic Parallel Font
Slope Rectangle Schematic Parallel Font
Slope Rectangle Schematic Parallel Font
 
1 - 1 of 1 Posts
Top