My Lawnmower Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
The unit will not roll even with the hydro release lever in the correct position ? So I got machine jacked up from the rear...and found the release cable, but there are no levers for it to hook to ? So I found the parts breakdown online, studied the transaxle section, and the two levers are shown facing the bottom of the trans axle, but for likes of me, I can't find where they go on the tansaxles ? Would any one have a service manual that would show a couple decent pictures of the transaxle and hydro release cable setup ?

Thank you,

Phil
 

·
Registered
Joined
·
15 Posts
Discussion Starter · #3 ·
Accoring to the parts schematic...they are Eaton X778-005 LH & X778-011 RH If that 'll help in the meantime ?

Thanks, Phillip
 

·
Ret. Moderator
Joined
·
498 Posts
Most of the time there is a nut right on the hydro pump that you need to turn that will release the hydro completely.
 
1 - 6 of 6 Posts
Top