Tried replacing the drive belt to the trans on my Scotts S1642 and noted the trans pulley wobbled a bit and feel I should try to .Please advise on how best to access this trensmission..Can the body or frame be unbolted and lifted off?
Off hand unless you can reach in from the side after removing the rear wheels I would guess your best bet to get to the pulley to check it out will be to remove the wheels, clips holding the linkage to the pedals and drop the transmission down from the frame.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.