My Lawnmower Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I redid my drive belts, taking the entire clutch assy apart in the process and after I reinstalled it, I cannon get the belt to operate without the idler pulley being compressed tween the 2 other pullys (the one on rear transaxle and the one one what I refer to as clutch assy). It appears that I reinstalled something different, but I dont know what. It is a 12hp transmatic, and when I put it in some gears, the pullys actually trap the idler between at one point or another and obviously that aint meant to be.

Can I have a photo of a good one, or any tips. I already have a schematic from mtd, but the photo is hard to decipher. Thanks.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.