My Lawnmower Forum banner

John Deere X500 snow blade adjustment

5158 Views 2 Replies 3 Participants Last post by  rhenning
I just installed a used 48" front blade with manual angling kit on an X500. It raises and lowers fine but when lowered the blade is still about 1 1/5" off the ground. There are two wheels on the blade frame that contact the ground and so far I cannot figure out what to adjust so the blade is lowered. I have tried changing the inner and outer lift assemby but that doesn't help. I would appreciate any suggestions. :confused:
1 - 1 of 3 Posts
You take the wheels off and put them on a rod sticking out of the right side of the frame of the blade. The wheels are only for moving the blade when not attached to the tractor. Roger
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top