home made sander

5148 Views 4 Replies 2 Participants Last post by searsjon, Aug 16, 2011

searsjon

Discussion Starter · Aug 15, 2011

i have a sears 18/6 twin and im building a sander for it so i can sand and plow with it in the winter but i was wondering if i could piggy back a small motor off the lights with out killing the alternator
Please help

Save

1 - 5 of 5 Posts

Mark / Ohio

· #2 · Aug 15, 2011

Welcome searsjon!

To be safe I would probably look up the alternator used on your specific engine by it's model number or the tractor model number. They aren't all the same output.

Save

searsjon

Discussion Starter · #3 · Aug 15, 2011

the model# for my sears is 917.25180, i think if i can use the existing line for the electric 3 pt and modify it i might be able to pass but i dont know how small the motor has top be and if i can run it with lights

Save

Mark / Ohio

· #4 · Aug 16, 2011 (Edited)

searsjon said:
the model# for my sears is 917.25180, i think if i can use the existing line for the electric 3 pt and modify it i might be able to pass but i dont know how small the motor has top be and if i can run it with lights

Looks like an Onan Twin. Sears still shows the exploded views for it.

http://www.searspartsdirect.com/par...ts/Model-91725180/0247/1509200/00010012/00001

Being Onan that makes it a little more tricky to come up with information. I ran across a photo of it in the 1977 Sears line up:

1977_tractors (Main page of the site: Vintage Sears Garden Tractors)

The regulator shows part # 7753R

Here's a wiring diagram of a tractor that appears very similar to yours except 18 hp but uses the same 7753r regulator with 30 amp fuse to the lift motor.

Appears Onans commonly used a 15 amp alternator.

Here's a list of Onan Service and parts manuals. You might be able to match up the numbers on your engine model/serial plate to one of them to know for sure.

ONAN PDF MANUAL Links - SmokStak

Onan Manuals Index - SmokStak

(I could not get the engine number shown on Sears site to come back to anything specific.)

or if all else fails this guy could probably look up and tell you. He's shutdown though now until September.

Onanparts.com, Your Onan Parts Solution

See less See more

Save

searsjon

Discussion Starter · #5 · Aug 16, 2011

thanks for ur help

it looks like the motor would have to be 12 amps or more but if all else fails ill run it on a pulley.

Save

1 - 5 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month