My Lawnmower Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
4 Posts
Discussion Starter · #1 · (Edited)
Hi All,

Working on a Craftsman LT1000 917.272670 .

I am rebuilding the Dana Spicer D4360-140 Transaxle that got water in it. The input bearings seem fine but since I have it apart I would like to replace them.. They do not have a part number for the bearing. It is only listed in a complete input shaft kit. Has anyone figured out a replacement bearing for this when the whole kit is not needed? Also I cannot find the rubber seal for the Gear Selector Shaft... Everywhere I find it, it states Discontinued.... Any ideas?
Thanks for any help.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top