My Lawnmower Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello,
I’m in need of some help trying to identify a engine part that’s broken on my Bolens 20” 450 series push lawn mower. The piece is made out of plastic and attaches to the gas tank and runs to a small hole towards the muffler. I attached some photos for a reference. I tried speaking with a customer service representative from Briggs and Stratton but they were unable to identify the part. Any help is appreciated. Thank you.
 

Attachments

·
Registered
Joined
·
25 Posts
The picture shows the engine model as 9L602-0927-F1
That would be the intake manifold. Connects the carburetor to intake port.
Briggs & Stratton 699644. Shows that it comes with gasket and screws. Tight to spec, snug not over tight.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
The picture shows the engine model as 9L602-0927-F1
That would be the intake manifold. Connects the carburetor to intake port.
Briggs & Stratton 699644. Shows that it comes with gasket and screws. Tight to spec, snug not over tight.
Thank you so much for the help!
 
1 - 3 of 3 Posts
Top