My Lawnmower Forum banner
1 - 2 of 3 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
A gear broke so I put a used gearcase in my old RM828. The workshop manual says to slide long axle in, install washer and roll pin then slide short axle in and rotate to engage springs.

Seems simple and I tried 3 times but no luck. Does anyone know what I am doing wrong?

1 - 2 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.