My Lawnmower Forum banner

Ariens RM828 gear case

1629 Views 2 Replies 2 Participants Last post by  Mark / Ohio
A gear broke so I put a used gearcase in my old RM828. The workshop manual says to slide long axle in, install washer and roll pin then slide short axle in and rotate to engage springs.

Seems simple and I tried 3 times but no luck. Does anyone know what I am doing wrong?

1 - 3 of 3 Posts
Fixed and mowing. The long axle had broken at the shoulder where it slides into the short axle. It was easy to see when compared to an unbroken axle.
Thanks John for returning to let us know what the resolution turned out to be and welcome to the forum!

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.