We went from no lawn in Taxifornia to 3 acres of lawn here near Bowling Green. I was going to buy a sub-compact tractor with a loader and 3-point hitch and belly mounted mower. Jack of all trades, master of none. I finally picked the tractor I wanted, but nobody on the planet had one nor could...

Hello everyone! I just registered and this is my first post. I just picked up my 2nd HR214. The first one I let $$ talk and sold it to make a few. Been regretting it ever since. This one I think I’m keeping. I haven’t given it much of a look yet other than when I was in the middle of buying a...

Hello, I Have Brigg & Startton 625 EX Series,YardWorks mower, Dont start with cold engine. If I poor little bit of gas in the air intake, behind air filter, it starts from the first pull, then stops, after couple of tries the engine keep going for hour. When the engine is hot I can even stop it...

The shoulder bolt and belville washer fell off, I found and reassembled to bolt, which fell off again. So I ordered a new one that has lock patch and a new belville washer. I put in and it would not tighten. The female threads are stripped. Any suggestions? I need to find someone to drill out...

Hi everyone! I am new to this forum and I am looking for some advice. I purchased a used MTD Yard Machine, with a 12.5 HP, 28T707-1154-E1 B&G engine for 175.00. It started right up, but it acted weird. The PO said he replaced the crankshaft and piston rings, but thinks the rings weren't...