My Lawnmower Forum banner

HRR2163TDA won't change speeds

6K views 3 replies 3 participants last post by  dspikes 
#1 ·
I'm working on this mower for a friend. The 3-speed cable housing/shift lever was broken, so it would only stay in one gear. I bought a new cable/housing and installed it. It runs fine, but still will not shift gears....it only stays in one gear. Any thoughts?
 
#3 ·
The change cable (controlled by the speed select lever) must move the shifter arm (yellow) on the outside of the transmission. The cable is anchored to the transmission case by a self-tapping screw, so make sure the cable is secure and verify the shift arm moves when changing speeds. There is a hole in the pulley to access the screw:

 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top